SP 1000SF

Maintenance

Service

General information

For your safety, it is imperative to

refer to the safety information CAUTION presented in chapter Security,

page 1.

To ensure that your machine is kept in the best conditions, it is recommended that you periodically clean the inner parts.

Please respect the following rules while using this machine:

-Do not leave the scanner cover open.

-Do not try to lubricate the device.

-Do not close the scanner cover violently or do not apply vibrations to the machine.

-Do not open the cartridge access cover while printing.

-Do not try to disassemble the machine

-Do not use paper which would has stayed in the tray for too long.

Toner cartridge replacement

Three toner cartridge replacement procedures can be used depending on the TONER MANAGEMENT setting.

•TONER MANAGEMENT setting set to WITH [0-10%] :the

replacement of the cartridge can be perfomed only when the message Toner near end is displayed. At the end of replacement, validation with the smart card is required.

•TONER MANAGEMENT setting set to WITH [0-100%] :

the replacement of the cartridge can be perfomed at any time. At the end of replacement, validation with the smart card is required.

•TONER MANAGEMENT setting set to WITHOUT : the

replacement of the cartridge can be perfomed at any time and no validation with the smart card is necessary. When set to WITHOUT, the screen displays

TONER ? %.

To set the TONER MANAGEMENT setting, select 2979 - SETUP / TECHNICALS / TONER MANAGEMENT and choose the setting.

This procedure applies when the setting TONER MANAGEMENT is set to WITH [0-10%].

CAUTION When set to With [0-100%], follow the procedure from step 2.

When set to WITHOUT, follow the procedure from step 2 to step 7.

Your machine comes with a current consumable

Maintenance-

To replace the toner cartridge, proceed as shown below.

management system. It tells you if your toner cartridge is

 

close to its end of cycle. The following message will

 

appear on your machine screen.

 

 

TONER NEAR

 

 

 

END

 

 

 

 

 

 

To quit this screen, press OK.

 

When the following message is displayed on the screen:

9

 

 

 

 

 

 

TONER EMPTY

 

 

REPLACE <OK>

 

 

 

 

 

 

1 Press OK.

 

 

 

 

 

 

OPEN FRONT COVER

 

 

REPLACE TONER

 

 

 

 

 

 

2Stand in front of the device.

3Push on the left and right sides of the cover and pull it towards you.

4Raise and remove the toner cartridge from the machine.

5Unpack the new cartridge and insert it into the slot as indicated in the diagram below.

6Close the cover.

The following message appears:

HAVE YOU CHANGEDTHE TONER? <OK>

7Press OK.

8When this message appears,

INSERT THETONER CARD

insert the smart card provided with the new toner cartridge as shown on the picture below.

- 50 -