ASSEMBLY

TO INSTALL SWITCH ASSEMBLY

See Figure 35.

NOTE: The switch assembly may be mounted on either the right or the left side of the saw.

Locate the following parts:

1 switch key

2 pan head screws with lock washers (10-32 x 3/8 in.) 2 square nuts (10-32)

Insert the pan head screws with lock washers (10-32 x 3/8 in.) through the holes in the switch assembly.

Thread the square nuts on the screws leaving at least a 1/8 in. clearance between the inside of the nut and the top of the switch assembly.

From either the left end or the right end of the front rail, with the switch assembly facing front, slide the square nuts into the lower slot of the rail and tighten securely.

NOTE: If mounted from the left end, the right side of the switch assembly should be in line with the left side of the table saw base. If mounted from the right end, the left side of the switch assembly should be in line with the right side of the table saw base.

TO SECURE THE ELECTRICAL CORDS

See Figure 36.

Three wire ties come with your table saw (one is extra). The motor cord and power cord should be routed along side the cabinet. Two holes provided on the side of the cabinet are used to secure the wire ties. Loop the motor cord in rear wire ties to remove excess slack. Lightly tap the wire ties into the holes of the cabinet using a hammer.

TO INSTALL END CAPS

See Figure 37.

Align the end caps of the front rail to the end of the rail. Secure using self-tapping pan head screw (M4) in each hole.

Repeat the above step for the rear rail.

FRONT RAIL

SQUARE

NUT

PAN HEAD

SCREW

SWITCH

ASSEMBLY

Fig. 35

WIRE TIE

WIRE TIE

Fig. 36

END CAP

SELF-TAPPING

PAN HEAD

SCREW

FRONT RAIL

END CAP

REAR RAIL

Fig. 37

27

Page 27
Image 27
RIDGID TS3660 manual To Install Switch Assembly, To Secure the Electrical Cords, To Install END Caps