RIDGID TS3660 manual To Store Accessories, To Install Front and Back Rails, Square Head Bolt

ASSEMBLY

TO STORE ACCESSORIES

See Figure 19.

The table saw has two convenient storage areas (one on either side of the saw cabinet) specifically designed for the saw’s accessories.

When not in use, store the accessories securely by snapping each accessory in place.

TO INSTALL FRONT AND BACK RAILS

See Figures 20 - 22.

To Install Front Rail:

Insert square head bolts (5/16-18 x 1 in.) into the holes on the front of the saw table and extension tables.

Attach flanged hex nut (5/16-18) loosely allowing the square bolt head to protrude.

Slide the front rail slot over each of the square head bolts and finger tighten the nuts.

Align the front rail with the 7-1/8 in. mark on the right side rip scale with the right edge of the cast iron table top.

To Install Back Rail:

Insert square head bolts (5/16-18 x 1 in.) into the holes on the back of the saw table and extension tables.

Attach flanged hex nut (5/16-18) loosely allowing the square bolt head to protrude.

Slide the back rail slot over each of the square head bolts and finger tighten the four nuts.

Place a framing square on either side of the blade. Move the back rail right or left until the indicator mark is aligned with the framing square. Finger tighten the nuts.

TOOL STORAGE

Fig. 19

SQUARE

HEAD

BOLT

	FLANGED
FRONT	HEX NUT
	(5/16-18)
RAIL

Fig. 20

SQUARE HEAD

BOLT

(5/16-18 x 1 in.)

FLANGED
HEX NUT
(5/16-18)	REAR
	EXTENSION
	RAIL
	Fig. 21
RIGHT EDGE OF
TABLE TOP

Fig. 22

22