Automatically updating the clock
Your radio will normally update the clock automatically when connected to the internet. If you enter a time setting manually, the radio will calculate a local time offset so that whenever it synchronises using the internet, the correct local time is stored in the radio. In the event of a power failure, your radio will connect to the internet and then set the clock automatically based on this information.
You may wish to use the radio away from the internet, in which case you may specify that the radio sets its clock from the time information in DAB radio broadcasts. After a power failure the radio will set its clock the next time that you turn on the radio in DAB mode.
Alternatively you may specify that the time is not automatically updated. In this case the clock must always be set manually after a power interruption
1.Access the main menu by pressing the Menu button until the 'Main menu' option is shown, then select this with the Tuning/Select control.
2.Rotate the Tuning/Select control until 'System setup' is highlighted on the display. Press the control to enter the system setup menu.
3.Rotate the Tuning/Select control until 'Time setup' is highlighted on the display. Press the control to enter the time setup.
4.Rotate the Tuning/Select control until 'Auto update' is highlighted on the display. Press the control to enter the
5.Rotate the Tuning/Select control to select from 'Update from NET', 'Update from DAB' or 'No update' as required. Press the control to confirm you choice. The radio will then exit to the previous menu display.
1
>Update from NE* Update from DAB No update
Update from NET >Update from DA* No update
55
