Roberts Radio WM-202 manual Key123-jones opqrstuvwx C

WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Some WiFi access points can also use pass-phrases for WEP but these do not conform to a defined standard and are not supported. WPA keys are usually set up using a pass-phrase of between 8 and 63 characters. Your Internet radio can accept pass-phrases for WPA keys.

12.To enter the WEP or WPA key, characters are selected and entered using the Tuning/Select control. As you rotate the control, the radio shows different sets of characters. The character currently flashing will be selected when you press the Tuning/Select control. Do this as needed until the complete key has been entered.

Remember, WEP keys only use the numbers 0-9 and letters A-F. WPA keys are sensitive to upper and lower case characters so you must enter them exactly.

If a WEP or WPA key has previously been entered the display will show 'Key: [Set]'. If you have previously entered a different key, you must clear this by selecting the < symbol. This will remove the '[Set]' indication

The three characters at the right-hand end of the list have special functions.

select '<' to erase a character or key previously entered

select ' ' when the key is complete

select 'C' to cancel and re-run the Network Wizard

13.After the final character of the WEP or WPA key has been entered, locate the ' ' symbol and press the Select control. The radio should now be able to connect to the network.

14.Once connected to your radio to the network (and therefore also to the Internet) it will display the main Internet Radio menu. Press the On/Off button to put the radio in Standby mode. It should then display the time. This time is obtained from the Internet by the radio. If the time display is not correct for any reason, it can easily be adjusted later, see page 53, 'Setting the clock'.

Configuration

Key:123-jones opqrstuvwx< �C

12-13

14

12