Roberts Radio WM-202 manual Jones family Paul’s network, Key, 0123456789

Connecting to your computer network - contd.

8.	If your network is not found, it is possible that it is configured such that	>Jones family
		Paul’s network
	the ESSID is not broadcast (sometimes referred to as hidden). If this
	is the case then the name will not be visible in the list (there may be	Smith
	a blank entry). You will then need to use the Tuning/Select control to	[Rescan]
	point to the '[Manual Config]' option, and then you should press the
	control to enter manual configuration. This procedure is described in	8-9
	the 'Network Configuration Menu', see page 14, 'Entering the network
	name manually'.	Smith
	If you know that your network name is not hidden, and it was not found,
	then either try re-scanning, or refer to 'Entering the WiFi network name	[Rescan]
	manually' on page 14.
	If you make a mistake at any point, use the Back option to go back to	[Wired]
	the previous screen.)	>[Manual config]
9.	When the ESSID for the access point you want to connect to is
	highlighted on the screen, press the Select control.
10.	If your network is configured without an encryption code, the screen
	should say 'Connecting...', and then show the main Internet Radio
	menu.
	If this is the case then you have successfully connected your radio to
	your network, so please proceed to paragraph 14 on the next page.
11.	If the screen displays 'Key:' , it is because the network is using one
	of the encryption systems: Wired Equivalent Privacy (WEP) or WiFi	Key:
	Protected Access (WPA). You therefore need to enter the correct		�C
	WEP or WPA key into the radio to allow it to communicate with your	0123456789<

network.

If you do not have the WEP or WPA key, then you should obtain it from the person who set up your network. Some WiFi routers may come with a key already set up by the supplier, in which case you should refer to the user documentation provided with it.

11