Roland GW-7 owner manual Turning the Power On/Off, Listening to the Demo Song

Models: GW-7

1 48
Download 48 pages 35.81 Kb
Page 9
Image 9

Connecting the AC Adaptor

1.Remove the GW-7 from its shipping carton, and place it on a horizontal surface.

2.Connect the included power supply cord to the included AC

adaptor.

fig.ACadap

AC adaptor

 

Power supply cord

 

 

 

 

 

 

 

 

 

 

 

 

to an AC outlet

Depending on your region, the included AC adaptor may be a different type than the one shown above. If so, omit step 2 and proceed.

3.Connect the AC adaptor to the DC IN jack on the GW-7’s rear panel, and then plug the AC adaptor into an electrical outlet.

To prevent the inadvertent disruption of power to your unit (should the plug be pulled out accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power

cord using the cord hook, as shown in the illustration.

fig.codef

Cord hook

GW-7 rear panel

Turning the Power On/Off

Turning the Power On

Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/ or damage to speakers and other devices.

1.Before you turn on the power, turn the VOLUME knob all the way to the left to minimize the volume.

2.Press the rear panel POWER button to turn on the power.

This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally.

If the GW-7 is connected to a keyboard amp or audio amp, turn on the power of the GW-7 first, and then switch on your amp.

3.Turn the VOLUME knob to adjust the volume of the GW-7.

Introduction

Turning the Power Off

1.Press the POWER switch once again to turn off the power.

If the GW-7 is connected to a keyboard amp or audio amp, switch off the power to your amp first, then turn off the power on the GW-7.

Adjusting the Screen Contrast

Hold down [FUNCTION] and turn the VALUE dial.

Listening to the Demo Song

1.Hold down [SHIFT] and press [EXIT] (DEMO).

The screen will indicate “DEMO PLAY.”

2.Press [START/STOP] to begin demo playback.

3.Press [START/STOP] to stop demo playback.

4.Press [EXIT] to return to the previous screen.

All rights reserved. Unauthorized use of this material for purposes other than private, personal enjoyment is a violation of applicable laws.

No data for the music that is played will be output from MIDI OUT.

Playing Sounds from the Keyboard (Keyboard Mode)

Immediately after you turn on the power, the GW-7 will be in a state where you can use the entire keyboard to play a piano sound. The GW-7’s keyboard can operate in one of the following three modes.

MAIN

The entire keyboard plays one Tone.

SPLIT

The region of the keyboard to the left of the split point

 

becomes the Lower Part, while the region of the key-

 

board to the right of the split point becomes the Upper

 

Part. Each part plays a different Tone.

DUAL

The entire keyboard plays two Tones simultaneously.

Using Main Mode

1.Turn on the power as described in “Turning the Power On”

A piano sound will be selected.

2.Select the desired Tone.

1.Press MODE [TONE] so the button is lit.

2.Turn the VALUE dial to step through the Tones one by one. Alternatively, you can press one of the ten buttons [PIANO]–[DRUMS] to select a Tone by category.

Refer to p. 11 for details.

3.Play the keyboard.

Turn the VOLUME knob to adjust the volume.

9

Page 9
Image 9
Roland GW-7 Turning the Power On/Off, Listening to the Demo Song, Playing Sounds from the Keyboard Keyboard Mode