r
= PL (PLay)
Function: Playback start
Syntax: stxPL;
Note: If the playback phrase has not been specified, the minimum default value (normally A001) will be used. The phrases specified by the PA command will be played back consecutively.
* If Dual Mono Mode is ON
Since phrases will be played back from the L or the R output depending on whether they are odd or even numbered phrases, phrases specified by the PA command will automatically be assigned to the playback memory;
= RL ( Relative time pLay )
Function: Playback from the Middle of a Phrase
Syntax: stxRL: * , **H**M**S**F ; stxRL: * , **H**M**S ;
| a | b |
|
a Locate Forward / Backward | b Offset Time | ||
0 | Backward |
| 0H0M0S0F – 11H59M59S |
1 | Forward |
| 0H0M0S0F – 11H59M59S**F |
Example) stxRL:1,0H10M59S0F;
-After specifying a phrase: Playback begins 10 minutes 59 seconds from the beginning of the phrase of the specified number.
-While playback is paused: Playback begins from the point that is 10 minutes 59 seconds after the point where the pause was initiated.
Note: The number of digits for **F (frame) increases according to the value of MTC type. The range in which the offset time can be specified is valid only within a single phrase. An offset time that exceeds the recording time for the phrase cannot be specified.
(The
*When “Return Specified” is issued with an offset time longer than elapsed time: The phrase is played back from the beginning.
*When “Forward Specified” is issued with an offset time longer than the remaining time: An ER command is output and playback is not carried out. (The paused state remains in effect, so specify a new offset time and send an RL command again.)
Caution: The command is not compatible with the Dual Mono.
Phrases other than audio phrases cannot be specified.
= ST (STop)
Function: Halting playback/recording
Syntax: stxST;
