Rose electronic Automatic Switch manual Disclaimer, Introduction, Features

Models: Automatic Switch

1 40
Download 40 pages 23.93 Kb
Page 5
Image 5

Introduction

Disclaimer

While every precaution has been taken in the preparation of this manual, the manufacturer assumes no responsibility for errors or omissions. Neither does the manufacturer assume any liability for damages resulting from the use of the information contained herein. The manufacturer reserves the right to change the specifications, functions, or circuitry of the product without notice.

The manufacturer cannot accept liability for damages due to misuse of the product or other circumstances outside the manufacturer’s control. The manufacturer will not be responsible for any loss, damage, or injury arising directly or indirectly from the use of this product.

Introduction

Thank you for choosing Caretaker Plus. Designed with your needs in mind, your new Caretaker Plus will make it possible for you to connect up to eight computers to a single printer, plotter, or other serial or parallel device for fast, efficient printer sharing.

This manual contains information for the installation and operation of the Caretaker Plus buffered automatic switch. The unit allows several computers or terminals to have shared access to a common printer, plotter, or other device. Accessing the shared device is done simply by sending data to the unit. Since the Caretaker Plus has buffer memory, each computer may simultaneously send data to the unit. The data is sent to the shared device in the order it was received.

All equipment is connected by cables to connectors on the Caretaker Plus rear panel. The unit's external power adapter connector and on-off switch are also on its rear panel. The Caretaker Plus front panel has 13 LEDs which display status information and 2 switches which are used to control the Led display, run the unit's diagnostics, and configure the unit.

Features

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

￿

Two to eight computers share one printer, plotter, or other device Serial (RS232) or parallel (Centronics), RS422 optional

Uses commonly available cables

Compatible with any computer – PCs, Macs, minis Compatible with all software and operating systems Compatible with all printers and plotters Simultaneous input from all computers

Up to two megabyte buffer

Serial units have programmable baud rate and flow control Programmable initialization strings and end-of-job form feed Units can be linked for more than 8 computers

Special noise protection features

Mode, data, busy, and error LEDs show data activity and status Self-test and diagnostic features

Made in USA

CARETAKER PLUS INSTALLATION AND OPERATIONS MANUAL

1

Page 5
Image 5
Rose electronic Automatic Switch manual Disclaimer, Introduction, Features