Metal
Hooks
Chest
Clip
Adjuster
Latch
Plates
Crotch
Buckle
4.To move the straps to the proper slot position, loosen the harness adjuster. At the back of the Sit’n’Stroll™ remove the shoulder belts from the metal hooks. Pull the shoulder belts from the front of the seat and place back through the desired slots. Reattach the shoulder belts to the metal hooks. Be sure the belts lay flat against the back of the seat shell. If they are over the stroller conversion handle you will not be able to convert the Sit’n’Strol™ to stroller mode.
5.Ensure the belts are not twisted.
6.Click the latch plates into the buckle. Pull up on both latch plates to ensure they are securely fastened.
7.Snap the chest clip back together. Slide the chest clip so it is at your child’s armpit level. If your child is smaller, you may need to remove the shoulder pads to fully tighten the harness and ensure proper placement of the chest clip.
8.Pull on the belt over the child’s left leg to snug the harness. This belt goes under the seat and attaches to the right lap and shoulder belts.
Tighten the harness by pulling the adjuster belt. The harness should be tight enough for you to only get one finger between the shoulder belt and your child.
9.To loosen the harness, squeeze the adjuster top and bottom and pull up.
Forward Facing
Proper adjustment of the harness system for use
1. Open the buckle by pressing the red button and pulling the latch plates from
Latch Plates
Crotch
RedBuckle
Button
the buckle. Open the chest clip.
2.Place your child into the seat, making sure their bottom is fully against the base of the seat.
3.The shoulder straps should fit through the shoulder belt slots, which are at or above the
8
