Safeline Sit'n'Stroll manual SafetyGuidelines

Models: Sit'n'Stroll

1 32
Download 32 pages 3.61 Kb
Page 6
Image 6

SafetyGuidelines

Warnings & Important Notes

This child restraint is designed for use by children who weigh between 5 and 40 pounds (2.3 kg to 18.1 kg) and whose height is between 18 and 40 inches (45.8 cm to 101.6 cm).

REAR-FACING this unit is certified for use with children from 5 to 22 pounds (2.3 kg to 9.9 kg). FORWARD-FACING it is certified for use from 20 to 40 pounds (9.1 kg to 18.1 kg).

Correct child restraint installation could be a matter of LIFE OR DEATH! You must read and follow both your child restraint and automobile owner’s manual.

If your vehicle does not have top tether anchors installed, you must contact your vehicle dealer or the vehicle manufacturer for parts, instructions and installation. See the list at the back of this manual for vehicle manufacturer contact information.

FAILURE TO FOLLOW THE MANUFACTURER’S INSTRUCTIONS ON THE USE OF THIS CHILD RESTRAINT SYSTEM CAN RESULT IN YOUR CHILD STRIKING THE VEHICLE’S INTERIOR DURING A SUDDEN STOP OR CRASH.

Accident statistics show that children are safer when properly secured in the back seat.

Do not use this child restraint rear-facingin the front seat of a vehicle that has a passenger side airbag unless the airbag is deactivated. Airbags inflate from 100-200 mph (161-323 kph). The airbag impact can cause severe injury or death.

If the Sit’n’Stroll™ is used forward-facingin the front seating position having an airbag, move the vehicle seat as far back from the airbag as possible.

Securely belt this restraint into the vehicle at all times. An unsecured child restraint may injure other occupants if a crash occurs.

The clothes your child wears will cause the harness fit to vary. It is neces- sary to adjust the tightness with EVERY trip.

To avoid injury, this restraint should be installed and adjusted by an adult. Never allow a child to buckle themselves into this car seat.

Metal and plastic parts can become very hot when exposed to the sun.

When not in use, place a blanket or towel over your Sit’n’Stroll™ if it will be in the sun for long periods of time. Check to be sure the metal and plastic parts are not too hot before placing your child in the seat.

If this restraint is involved in an accident, replace it regardless of appearance. The vehicle seat belt must also be replaced. Damage is not always visible.

SecuretheSit’n’Stroll™inthecaratalltimes evenwhennotinusebyyourchild. Intheeventof asuddenstoporcollision,anunbeltedcarseat couldinjureotheroccupantsinthecar.

4

Page 6
Image 6
Safeline Sit'n'Stroll manual SafetyGuidelines