TopTether Information
A top tether provides additional protection for your child. The tether reduces the possibility of serious head and neck injuries, which can cause lifelong disability or death.
Proper tether anchor hardware is required to securely fasten the top tether of the Sit’n’Stroll™ in your vehicle. Check your vehicle owner’s manual for details on tethering child restraints. Most vehicles have top tether anchor kits available. Contact your vehicle dealer to obtain the top tether anchor hardware and installation or your vehicle. In many cases, you will be able to install the hardware yourself. After September 1, 1999, most new cars will have anchors as standard equipment. Most vans, SUV’s and pickup trucks will have anchors a year later.
If your vehicle dealer is unable to assist you or you have additional questions, a listing of telephone numbers and web sites for most vehicle manufacturers is located at the back of this manual.
Installing theTopTether with the Sit’n’Stroll™ Rear Facing
A rear facing child restraint may be tethered to the floor area in front of the seat. These anchor points may be identified in the vehicle owner’s manual. Please consult the vehicle owner’s manual, dealer or manufacturer for detailed information on suitable anchor loca- tions.
1.The Sit’n’Stroll™ top tether attaches to a bracket under the stroller handle. Clip the hook end of the tether to the Sit’n’Stroll™ tether bracket before placing in the vehicle seat. Next, secure the Sit’n’Stroll™ with the vehicle seat belts.
2.Clip the adjuster end of the top tether to the vehicle anchor point.
3.Pull the tether adjuster strap to tighten the top tether. The Sit’n’Stroll™ seat back angle should not be lower than 45- degrees from horizontal.
4.To release the top tether, pull up on the tether adjuster tab. If the tether is very tight, pushing down on the back on the Sit’n’Stroll™ will help release the adjuster.
DO NOT
THE SIT’N’STROLL™ IS REAR FACING! A seat back angle of less than 45
Installing theTopTether with the Sit’n’Stroll™ Forward Facing
1.The Sit’n’Stroll™ top tether attaches to a bracket under the stroller handle. Clip the hook end of the tether to the Sit’n’Stroll™ tether bracket before placing in the vehicle seat.
2.Clip the adjuster end of the tether to the anchor in the vehicle behind the Sit’n’Stroll™ .
3.Secure the Sit’n’StrollTM with the vehicle belts.
4.Pull on the tether adjuster strap to tighten.
5.To release the top tether, pull up on the adjuster tab. If the tether is very tight, pushing back on the Sit’n’Stroll™ will help release the adjuster.
20
