Converting the Sit’n’Stroll™ fr om Stroller to Car Seat
Tips
Tips
1.Compress the red handle release tabs and push the stroller handle down until it locks in its lowest position.
2.Align the front wheels by rolling the stroller back 6 to 12 inches. Place one hand in the slot handle located between your infant’s feet. With your other hand, grasp the slider grip located on the back of the seat. Lift the seat off the ground.
3.Squeeze the red lock release evenly with your fingertips and slide the slider grip up to its stop position. Relax your finger pressure on the red lock release. Push down on the slider grip to ensure the wheels are properly locked. The wheels should now be stored behind their protective flaps.
Maneuvering Over Curbs: Always back up to the curb, pull up on the telescoping handle and lift the rear wheels over the curb. Pull the stroller backwards and allow the front wheels to ride up over the curb. Never push down on the telescoping handle to prop the front wheels on the curb first.The pressure placed on the handle may cause damage.
Locking the Wheels: When converting the Sit’n’Stroll™ from stroller to car seat, the wheels must lock in the uppermost position.To ensure the wheels lock properly, keep your finger tips on the slider and sqeeze evenly over the entire surface of the slider button until the wheels are up. Grab the top of the seat (near the red handle release tabs) with your thumb and squeeze your thumb and fingers together until the wheels click into place, indicating the wheels are properly locked.
1.2.3.4.
Hold the unit in | Deploy the | Place the Sit’n’Stroll on | Away you go! |
the air to | wheels. | the ground and deploy |
|
convert. |
| the handles. |
|
24
