Safeline Sit'n'Stroll manual Manually Adjusted Lap Belts and Locking Latch Plates

Manually Adjusted Lap Belts and Locking Latch Plates

Rear-Facing Tabs

1.Place the Sit’n’Stroll™ in a rear facing position in the car.

2.Thread the lap belt through the rear facing vehicle-belt tabs. Click the latch plate into the buckle.

3.Push down firmly on the Sit’n’Stroll™ to sink it into the car’s seat cushion, while pulling on the end of the lap belt or shoulder part of the lap/shoulder belt. You may have to press on one armrest at a time to get the auto belt tight. Pull the seat belt as tight as possible across the unit.

4.Be sure the back of the Sit’n’Stroll™ is at a

45-degree angle. The base of the seat should be horizontal. Use a tightly rolled towel or sheet under the seat base to adjust the angle if necessary.

5.Secure the top tether to the tether anchor in the vehicle if desired.

6.Lift up on the Sit’n’Stroll™ to check that it is securely tightened. If it moves away from the auto seat, retighten the auto seat belts.

7.If you have tightened the belt and it is still not secure, move it to another seating location and repeat steps 1-6. If there is no location in your vehicle that will securely hold the restraint, do not use it! Contact you vehicle dealer to have a vehicle belt installed that will remain tight.

Be sure the car seat belts are not twisted.

13