Samsung CLP-300 Series manual Load paper with the print side up

5Flex the paper sheets back and forth to separate the pages and then fan them while holding one edge. Tap the edges of the stack on a flat surface to even it up.

7Squeeze the paper length guide and slide in it until it lightly touches the end of the paper stack.

6Load paper with the print side up.

Make sure not to overfill the tray and that all four corners are flat in the tray and under the brackets, as shown below. Overfilling the tray may cause a paper jam.

8Close the paper cover.

9Slide the tray back into the printer.

NOTE: If you want to change the size of the paper in the tray, refer to “Changing the Size of the Paper in the Tray” on page 2.5.

NOTE: After you load paper, you need to set up your printer for the paper type, size, and source you loaded. For details, see the Software Section.

2.4

Setting Up Your Printer