Samsung CLP-300 Series manual

5Extend the top handle on the imaging unit and then use it to pull the imaging unit out of the printer completely.

6Take a new imaging unit out of its package. Remove the protective devices on both sides of the imaging unit and the paper protecting the surface of the imaging unit.

CAUTION:

•Don’t use sharp objects, such as a knife or scissors, to open the imaging unit package. You could damage the surface of the imaging unit.

•Be careful not to scratch the surface of the imaging unit.

•To prevent damage, do not expose the imaging unit to light for more than a few minutes. Cover it with a piece of paper to protect it if necessary.

7Holding the handles on the new imaging unit, push the imaging unit until it sounds 'click' in to the printer.

8 Remove four dummy caps which are on the toner cartridge entrances of the imaging unit.

9 Insert the toner cartridges and waste toner container into their corresponding slots until they click into place.

10Close the front cover firmly.

CAUTION: If the front cover is not completely closed, the printer will not operate.

11Turn the printer on.

CAUTION: If there is a cracking sound, re-install the imaging unit. The imaging unit is not properly installed.

NOTE: Each LED blinks red in a repeated order. Wait for about 3 minutes for the printer to get ready.

5.5

Maintaining Your Printer