UNDERSTANDING THE CONTROL PANEL
The color of the status and toner colors LED indicates the machine's current status.
LEDs
STATUSD LED | TONER COLORS LED | DESCRIPTION |
|
|
|
lights green | all LEDs off | The machine is ready to print. |
|
|
|
slowly blinks green | all LEDs off | The machine is receiving data from the computer. |
|
|
|
fast blinks green | all LEDs off | The machine is printing data. |
|
|
|
lights red | all LEDs off | • The machine is experiencing an error, such as open cover, empty paper, not installed waste |
|
| toner container, or full waste toner container. |
|
| • The machine is experiencing a service required error, such as LSU error, fuser error, or ITB |
|
| error, Contact your sales or service representative. |
|
|
|
lights orange | all LEDs off | • The machine is experiencing an error such as jammed paper. |
|
| • While the machine is booting up, do not open a top cover, since the machine may treat it as an |
|
| error such as paper jam. In this case, open a front cover and close it then, the machine will |
|
| reboot up. |
lights green | each LED blinks red | Each toner cartridge is near the end of its life. |
|
|
|
blinks red | each LED lights red | Each toner cartridge is almost empty. You can print, but the quality is not reliable. |
|
|
|
lights red | each LED lights red | • Each toner cartridge is totally exhausted. You can not print. |
|
| • Each toner cartridge is wrong. |
lights green | each LED blinks red in a | The machine is warming up. |
| repeated order |
|
All printing errors will be appear in the Smart Panel program window. | ||
Stop button
STATUS LED | DESCRIPTION |
|
|
Printing demo page | In Ready mode, press and hold this button for about 2 seconds until the status LED blinks slowly, and release. |
|
|
Printing configuration sheets | In Ready mode, press and hold this button for about 5 seconds until the status LED blinks fast, and release. |
|
|
Canceling print job | Press this button during printing. The red LED blinks while the print job is cleared from both the machine and the |
| computer, and then the machine returns to ready mode. This may take some time depending on the size of the print job. |
|
|
18_Introduction
