Samsung Digimax U-CA +/- button, White paper, such as lighting value or subject brightness

+/- button

Using the Custom White Balance

White balance settings may vary slightly depending on the shooting environment. You can select the most appropriate white balance setting for a given shooting environment by setting up the custom white balance.

1. Select the CUSTOM ( ) menu of the White Balance.

2. Place a sheet of white paper in front of the camera so that

the LCD monitor's auto focus frame ( ) shows only white, and then press the SHUTTER button.

3. Your custom white balance value will be stored.

4. Press the +/- button. The white balance menubar will disappear.

-The custom white balance value will be applied to the next picture you take and thereafter.

- The custom white balance value will not change until you set it again to another value.

White paper

ISO: You can select the ISO sensitivity when taking pictures. The speed or specific light-sensitivity of a camera is rated by ISO numbers. This is available only in Auto or Manual mode.

Selecting an ISO Sensitivity
1. Press the +/- button, and the use the UP button to select
the ISO icon(	). The ISO menu bar will appear as
shown.
2. Use the LEFT and RIGHT buttons to select the desired
ISO sensitivity value.
- AUTO	: The camera's sensitivity is
	automatically changed by variables
	such as lighting value or subject brightness.

-100, 200, 400 : You can increase the shutter speed while the same amount of light is present, by increasing the ISO sensitivity. However, the image may be saturated in high luminance.

The higher the ISO value, the higher the camera’s sensitivity to light is and therefore the greater its capacity to take pictures in dark conditions. However, the noise level in the image will increase as the ISO value increases, making the image appear coarse.

3.When you press the +/- button again, the value you set will be saved and ISO setup mode will end.

33