▌Sound
No sound.
Checkpoint 1 Are you watching a program in scan mode?
If you are playing a program at a speed other than normal and fast1 speed, the sound will not be heard.
Checkpoint 2 | Check the connections and settings. |
Checkpoint 3 Check whether the disc is damaged. Clean the disc, if necessary.
Checkpoint 4 | Check whether the disc is inserted |
| correctly with the label facing up. |
No audio output.
Checkpoint 1 Check whether you have selected the correct digital output options in the Audio Output Options menu.
(See page 38)
▌Timer Recording
Timer lamp flickers.
Checkpoint 1 | Check if there is enough space in the |
| disc for recording. |
Checkpoint 2 | Check whether the current disc is |
| recordable or not. |
| Make sure to check before the start |
| time of recording. |
Timer recording does not work properly.
Abnormal HDMI output screen.
Checkpoint 1 | If snow noise appears on the screen, |
| it means that the TV does not support |
| HDCP |
| Protection). |
| If connected via DVI, try turning the DVD |
| Recorder off then On. |
HDMI output Jitter | |
Checkpoint 1 | Check your TV system setup correctly. |
Checkpoint 2 | Screen Jitter may occur when the frame |
| rate is converted from 50Hz to 60Hz |
| for 720p/1080i HDMI (High Definition |
| Multimedia Interface) Output. |
Checkpoint 3 | Please refer to the user's manual of your TV. |
▌Remote Control Unit
The remote control doesn't work.
Checkpoint 1 | Point the remote control at the remote |
| control sensor on your DVD recorder. |
| Allow for proper distance. Remove |
| obstacles between your DVD recorder and |
| the remote control. |
Checkpoint 2 | Check whether the batteries are empty. |
▌Other
I forgot my password for parental supervision.
Checkpoint 1 Remove the disc. Press the CH ( / ) |
buttons on the front panel of the DVD |
Checkpoint 1
Checkpoint 2
Recording will be cancelled, if the power is disconnected due to a power failure or other similar reason, while recording.
Recorder simultaneously for 5 seconds or |
more when the power is on. |
All settings including the password will |
revert to the factory settings. Do not use |
this unless absolutely necessary. |
(Note that this function is possible only |
when no disc is inserted.) |
Additional Information
▌HDMI
No HDMI output.
Checkpoint 1 | Check to see that the Video output is HDMI |
| enabled. |
Checkpoint 2 | Check the connection between the TV and |
| the HDMI jack of the DVD Recorder. |
Checkpoint 3 | See if your TV supports 480p/720p/1080i |
| resolution. |
Is it possible to change a subtitle and an audio signal on a recorded disc?
Checkpoint 1 A recorded disc is played with only the subtitle and the audio signal which were selected during recording.
Other problems.
Checkpoint 1 Read the table of contents and then find and read the section describing your problem, and follow the instructions given.
Checkpoint 2 | Turn your DVD recorder off and on. |
Checkpoint 3 If the problem still persists, contact a nearby Samsung service center.
