Antenna + Cable box or satellite receiver (set top box) + DVD Recorder + TV : Cable box/Satellite receiver with a video/audio output
You can record channels by selecting the channel on the cable box or satellite receiver (set top box).
You cannot record one channel while watching another channel. Be sure that the cable box or satellite receiver (set top box) is turned on.
Connecting & Setting Up
Connecting the IR Blaster cable into the Cable Box Control jack The Cable Box Controller (IR Blaster) is used to control your cable box for recording purposes.
1.Find and Connect the included IR Blaster cable into the Cable Box's Control jack of the DVD Recorder.
2.Find the Cable Box IR Sensor
A.Turn the cable box Off.
B.Hold the Cable box/Satellite receiver's remote so that it touches the front of the Cable box/Satellite receiver (see Figure 1).
(Press and release the power button each time you move the remote; holding down the button will not work.) D. When the Cable box/Satellite receiver powers On, you have found the sensor.
E. Remember the location of the sensor.
3.Place the IR Blaster.
Place the Cable box controller of the IR Blaster on top or underneath the Cable box/Satellite receiver approximately 1 inch in front of the sensor you found in 2. Use the
Figure 1
Correct Incorrect
C. Move the Cable Box's remote across the front of the Cable Box/Satellite Receiver while pressing the remote's power button On and Off (Figure 2).
■You must select a Cable box/Satellite receiver brand from the table on pages 81~83. If you do not know the brand name, please contact your cable/satellite provider.
■After setting up your cable box or satellite receiver (Set top box) with the DVD recorder through the IR Blaster cable, you need to set up the Set Top Box Control menu. (See pages 32~33)
Figure 2
English - 16
