Samsung DVD-R129/XEH, DVD-R129/EUR manual Audio Options, Press the …† buttons to select Audio, then

Press the …† buttons to select Audio, then	DTS
3 press the OK or √ button.

Audio setup menu will be displayed.

DVD-Recorder			Audio
No Disc
Programme	Digital Output	: PCM	√
Setup	DTS	: Off	√
	Dynamic Compression : On		√
	NICAM	: On	√
MOVE	OK	RETURN	EXIT

1. Off : Doesn’t output DTS signal.

Select this when your AV receiver or AV amplifier does not have DTS decoder.

2.On : Outputs DTS Bitstream via digital output when you play DTS track.

Select this only when your AV receiver (or AV amplifier) have DTS decoder.

	■ When DTS soundtrack is played, sound
NOTE	does not output from AV Audio Output.

4 Press the …† buttons to select the desired audio option, then press the OK or √ button.

DVD-Recorder			Audio
No Disc
Programme	Digital Output	PCM
Setup	DTS	Bitstream
	Dynamic Compression : On		√
	NICAM	: On	√
MOVE	OK	RETURN	EXIT

5 Press the …† buttons to select the desired item, then press the OK or √ button.

■ Press the RETURN or œ button to return

Dynamic Compression

This is only active when a Dolby Digital signal is detected.

1.Off : You can enjoy the movie with the standard Dynamic Range.

2.On : When Movie soundtracks are played at low volume or from smaller speakers, the system can apply appropriate compression to make low-level content more intelligible and prevent dramatic passages from getting too loud.

NICAM

NICAM programmes are divided into 3 types. NICAM Stereo, NICAM Mono and Bilingual (transmission in another language). NICAM programmes are always

System Setup

NOTE

to the previous menu.

Press the MENU button to exit the menu.

accompanied by a standard mono sound broadcast and you can select the desired sound by setting NICAM on or off.

Audio Options

Digital Output

1.PCM : Select this when you have no equipment that can decode Dolby Digital (or MPEG-2) signal. When you play Dolby Digital (or MPEG-2) sound track, the digital output are converted to PCM Stereo.

2.Bitstream : Output Dolby Digital (or MPEG-2) audio as bitstream. Select this when your AV receiver or AV amplifier have Dolby Digital (or MPEG-2) Decoder.

■ Digital output setting is equally applied to

1.On : NICAM mode

2.Off : Only set at this position to record the standard mono sound during a NICAM broadcast if the stereo sound is distorted due to inferior reception conditions.

NOTE

both Dolby Digital and MPEG-2 audio. LPCM sound track is always outputted as PCM. It has no relation with Digital Output setting.

■Be sure to select the correct Digital Output or you will hear no sound or loud noise.

English -33