㩷
Control specification
1.Key and Switch
BUZZER | : | In alarm condition, buzzer stops sounding with this key pressed. | ||
|
|
|
| Remote alarm output and alarm message would not be off. |
|
|
|
| During the power failure (battery |
|
|
|
| present temperature of PT sensor. |
ALARM TEST | : | With this key pressed to activate alarm test mode to be forcibly step into | ||
|
|
|
| alarm condition (ALARM lamp blinks, intermittent buzzer beeps, digital LED |
|
|
|
| goes off and remote alarm inputs). |
|
|
|
| After approx. 90seconds then, normal condition retrieves with Auto Return |
|
|
|
| activates. |
|
|
|
| With the battery switch turns off, “E09” blinks on the display. |
SET | : | Press this key once to activate set mode (2nd digit in LED blinks), press the | ||
|
|
|
| key again to store the value to be changed. |
|
|
|
| With Key Lock setting mode (“L 0” or “L 1” is displayed), press the key to |
|
|
|
| store the value to be changed. |
|
|
|
| During setting mode, the blinking digit shifts among the 1st digit or the 2nd |
|
|
|
| |
|
|
|
| digit or 3rd digit. |
|
|
|
| |
|
|
|
| During setting mode, count the blinking digit up. In PV display, press the |
|
|
|
| key over 5 seconds to enter the function mode. (“F00” is displayed) |
2.Temperature control
Setting range | : |
|
|
| ||
Display range | : | ~+50 |
|
|
| |
Setting procedure | : | Press SET key and set the required value with | key and |
| key. | |
|
| Press SET key to store the set value. |
|
|
| |
Out of setting range : | If you try to set the value which is out of temperature setting range, it is | |||||
|
| unacceptable with buzzer beeps for 1second. |
|
|
|
3.Temperature alarm
Setting range | : | High temperature alarm … +5 | ~+20 | (Initial setting: 10 | ) | |
|
| Low temperature alarm …. | (initial setting: | ) | ||
Setting procedure | : | Keep pressing | key over 5 seconds to enter function mode (F00). | |||
|
| Input “F01” for high temperature alarm or “F02” for low temperature | ||||
|
| alarm. Press SET key to set the value to be changed with the 1st digit | ||||
|
| blinks. Press SET key again to store the value in the | ||||
|
| memory. |
|
|
|
|
Out of setting range : | If you try to set the value which is out of alarm setting range, it is | |||||
|
| unacceptable with buzzer beeps for 1 second. |
|
4.Key Lock mode and Function mode
A) Key Lock mode |
|
|
|
|
Setting range : | 0, 1 |
|
|
|
Setting procedure: | In PV display, keep pressing |
| key over 5 seconds to enter into Key | |
| Lock mode. (“L_0” or “L_1” is | displayed. initial: L_0) with “0” or “1” blinks. | ||
| Change the value with | key and press SET key to store the value in | ||
| the |
|
|
|
15