Sanyo MDF-C8V service manual Installation of MTR-85H, Temperature Recorder Option

TEMPERATURE RECORDER (OPTION)

Installation of MTR-85H

1.Remove 4 screws (A, B, C, D) on the side of the front panel to take off the front panel. Then remove 4 screws on the cover for the recorder mounting space and take off the cover (Fig. 1). After removing the cover, replace 4 screws.

2.As shown in Fig. 2, install the recorder to the front panel by using the fixture enclosed with the recorder and the mounting plate (MDF-S3085).

3.Lead the recorder sensor to the chamber through the access port at the bottom of the chamber.

Note:

The port is covered with a thermal insulation and rubber cap. Remove those covers before passing the recorder sensor.

4.Fix the recorder sensor to the inside of the sensor cover (MTR-C8) by using the enclosed clips and screws and seal the access port on the chamber side with a silicon. (Fig. 3)

Front panel

A

C

D

Cover

B

Fig. 1

Mounting plate

Recorder

Fixture

Fig. 2

Silicon

Recorder sensor

Sensor cover

Fig. 3

31

64