Using the Tape Counter

The tape counter:

Indicates the elapsed time in the play and record modes (hours, minutes and seconds)

Is reset when a cassette is inserted in the DVD-VCR

Allows you to find the beginning of a sequence easily

If the remaining time is to be calculated correctly, you must indicate the type of cassette being used.

1Insert a cassette in your DVD-VCR.

2To set the tape counter to zero at the beginning of a sequence:

Press INFO. twice to display the counter

Press CLEAR when you want to set the tape counter to zero.

0:00:00

3When you are ready,

Start playback or Recording.

Press the button.

To fast-froward or rewind to the sequence at which the counter was set to zero, press ➛➛ or

❿❿.

Some DVD-VCR information, such as the counter, can be displayed on the television screen (unless you have deactivated the Screen messages mode; refer to page 16).

Press INFO.:

Once to display the current function, programme number, recording speed, date, time and counter

Twice to display the counter only

Three times to display the time remaining on the cassette

Four times to clear the display

Using the Assemble Edit Function

This function allows you to start a new recording at a specific position on the cassette while maintaining a very smooth scene change.

1Insert the cassette to be edited in your DVD-VCR.

2Press the ll button to start playback.

3When you reach the position from which you wish to start the new recording, press the ll button.

4Press the F.ADV/STEP button again as often as necessary to advance frame by frame, until the exact recording position is located.

5While the DVD-VCR is in still mode, hold the REC button () down for a while to activate the Assemble Edit function.

6Select the source from which you wish to record by pressing:

The PROG buttons for television channels

The INPUT SEL. button for the LINE input sources

7Press the ll button to start recording.

8When you have finished recording, press .

ENG-23

Page 24
Image 24
Samsung DVD-V940K instruction manual Using the Tape Counter, Using the Assemble Edit Function, Tape counter