ENG-8
Tuning Your Television for theDVD-VCR
You must tune your television for the DVD-VCR only if
you are not using a AVcable
➢
To view pictures from your DVD-VCR when a AV
cable is used, the television must be set to the
audio/video mode (AV).
1Switch on the television.
2Switch on the DVD-VCR by pressing STANDBY/ON
on the front of the DVD-VCR or STANDBY/ON on
the remote control.
3Select a programme position on the television to be
reserved for use with your DVD-VCR.
4Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette; if
not, press
❿
II
button.
5Start a scan on your television or set the television
to UHF channel 36.
6Fine tune the television until the pictures and sound
are obtained clearly.
7If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 45).
8When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.
Plug & Auto Set up
Your DVD-VCR will automatically set itself up when it
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
1Connect the coaxial cable as indicated on page 6.
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
2Plug the DVD-VCR into the mains.
Result: The Auto Setup is started automatically.
3Select the required language by pressing the
or
❷
buttons.
4Press OK to store the language selected.
Result: A message appears.
5Press OK to start the auto scanning.
◆
The number of stations automatically stored by
the VCR depends on the number of stations
that it has found.
6The current time and date are displayed
automatically. Check the date and time. if it is :
◆
Correct, Press RETURN button twice to exit the
menu.
◆
incorrect, see page 10.
➢
Auto preset can be performed by pressing
■
on
the front panel continuously for 5 seconds or
more with no tape inserted in VCR mode.