Chapter 4. Remote control
82
Problem | Possible Solution |
The message | • You cannot use the remote control when you are |
“Disconnecting | configuring Anynet+ or switching to a view mode. |
Anynet+ device ...” | • Use the remote control after the product has |
appears on the screen. | completed Anynet+ configuration or has finished |
| switching to Anynet+. |
|
|
The Anynet+ device | • You cannot use the play function when initial setup is in |
does not play. | progress. |
|
|
The connected device | • Check whether or not the device supports Anynet+ |
is not displayed. | functions. |
• Check whether or not the HDMI cable is properly connected.
• Check whether Anynet+
• Search Anynet+ devices again.
• Anynet+ requires an HDMI connection. Make sure the device is connected to your product with an HDMI cable.
• Some HDMI cables may not support Anynet+ functions.
• If the connection is terminated because there has been a power failure or the HDMI cable has been disconnected, please repeat the device scan.