Printing a demo page
After setting up your printer, print a demo page to make sure that the printer is operating correctly.
Press and hold Demo for about 2 seconds.
Or,
1Press Menu and then OK when 1. Information appears.
2Press the Scroll buttons until Demo Page appears and press OK.
3Press OK when Yes appears. A demo page prints out.
Changing the display language
To change the language that is displayed on the control panel, follow these steps:
1Press Menu until 5. System Setup appears on the bottom line of the display and press OK.
2Press the Scroll buttons until Language appears and press OK.
3Press the Scroll buttons to select the language you want and press OK.
4Press Stop to return to Standby mode.
Using toner save mode
Toner save mode allows the printer to use less toner on each page. Activating this mode extends the life of your toner cartridge and reduces your cost per page beyond what one would experience in the normal mode, but it reduces print quality. This setting is not available with the
There are two ways to enable this mode:
Using the control panel button
Press Toner Save on the control panel. The printer must be in Standby mode; the Status LED lights green and Ready is shown on the display.
•If the button backlight is on, the mode is enabled and the printer uses less toner to print a page.
•If the button backlight is off, the mode is disabled and the printer prints in normal mode.
From the software application
You can set toner save mode from the printer properties window on your printer driver. See the Software Section.
Changing the font setting
Your machine has preset the font for your region or country. If you want to change the font which you prefer or set the font under special condition such as the DOS environment, you can change the font setting as follows:
1Press Menu on the control panel until you see 6. Emulation feature.
2Press OK to access the font setting.
3Press the left/right arrow until Setup displays.
4Press the left/right arrow until PCL displays.
5Press the left/right arrow until Symbol displays.
6Press the left/right arrow until your preferred font displays.
7Press OK.
8Press Stop to return to machine ready mode.
Note
Following information shows the proper font list for corresponding languages.
•Russian: CP866, Cyrillic
•Hebrew: 15Q, 8H, 0H (Israel only)
•Greek: GREEK, PC737
•Arabic & Farsi: ARABIC8, WINARABIC, PC864, FARSI,
ISOARABIC.
2.8 <System setup>
