through a
-If the IP address is configured to DHCP (Obtain an IP address automatically) in TCP/IP properties, IP address is configured within the same subnet range automatically.
-If the IP address is configured to static IP in TCP/IP properties, select Use the following IP address in the TCP/IP properties of the wireless adapter, configure IP address:10.0.0.1~10.0.0.254, and Subnet mask: 255.255.0.0, and then try again.
Q8 When using a
AIt may happen occasionally when you are using a
Q9 Running Help file while running Profile Wizard in the wireless LAN program (PROSet) makes the PROSet window white.
AIt will be displayed properly when you finish the profile wizard. It dose not affect the program operation.
Q10 The network does not operate properly when both the wireless and the wired network connections are simultaneously configured with the same IP address.
AYou cannot use the wireless and the wired network connections using the same IP address simultaneously. To use either the wireless or the wired network in turn with the same IP address, you have to Disable whichever network device will not be using in the network connection of the Control Panel.
Q11 The wireless LAN does not operate properly when there are other products operating in the 2.4GHz band.
A1 Since IEEE 802.11b and IEEE 802.11g equipment uses a common frequency or the ISM band, channel interference may occur when a wireless video transceiver or a microwave oven is being used. If you experience channel interference from other equipment, it is recommended changing the channel to connect to the AP.
A2 IEEE802.11g equipment operates in hybrid mode when there is active IEEE802.11b equipment. This may result in data rate degradation.
96 Users Manual
