Spacer

Spacer

•Remove paper on spacer and then attach a spacer (Gray block) on the back side of refrigerator for better performance. Make sure a spacer fix like above image when you install the refrigerator. It is improving the refrigerator performance.

(Only for RB31F***B, RB29F***B, RB37J***9**, RB33J3**9, RB33N*, RL33N* model)

•Allow sufficient space to the right, left, back and top for air circulation.

This will help reduce power consumption and keep your energy bills lower.

•Do not install the refrigerator where the temperature will go below 10 °C.

•Please ensure that appliance can be moved freely in the event of maintenance & service.

When installing, servicing, or cleaning CAUTION behind the refrigerator, be sure to pull the

unit straight out and push back in straight after finishing.

Also, make sure your floor supports the full-load refrigerator.

Otherwise, it may cause floor damage.

Please tie up the extra length of the power CAUTION cord at the back of the refrigerator so as

not to be touched on the floor preventing the power cord from being crushed by the rollers upon relocation.

FLOORING

For proper installation, this refrigerator must be

 

 

placed on a level surface of hard material that has

 

 

the same height as the rest of the flooring.

 

 

This surface should be strong enough to support

up

 

a fully loaded refrigerator (or approximately 65 kg).

 

 

 

To protect the floor finish, cut a large section of the

 

 

cardboard carton and place it under the refrigerator

 

 

where you are working.

 

 

• Pulling or pushing the refrigerator may

setting01

 

 

 

damage the floor.

 

 

Moving the refrigerator after installation

 

 

may damage the floor.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

•When you move the refrigerator, the Power Cord should be fixed with the fixer of the back side.

(Some model’s fixer on the cabinet bottom or wire holder)

[Fixer on the cabinet bottom]

[Fixer on the wire holder]

setting up _17

DA68-02833Q-18.indb 17

2018. 2. 2. �� 9:15