Removing residual matter inside the water supply line after installing a new filter

1.Press the Water button, and then push the Dispenser Lever with a cup or glass.

2.Flush 1 gallon of water through the filter, one

cup or glass at a time. (Flush approximately 6 minutes.) This will clean the water supply system and remove air from the lines.

-Additional flushing may be required in some households.

3.Open the refrigerator door and make sure there are no water leaks coming from the water filter.

Reverse Osmosis Water Supply

IMPORTANT : The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)

If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.

Allow the storage tank on the reverse osmosis system to refill after heavy usage.

If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter.

If you have questions about your water pressure, call a licensed, qualified plumber.

Ordering replacement filters

To order more water filter cartridges, contact your authorized Samsung dealer.

02operating

operating _71

Page 71
Image 71
Samsung RSG309** user manual Reverse Osmosis Water Supply, Ordering replacement filters