
1.Connect the household water line to the assembled compression fitting.
-If you are using copper tubing, slip the compression nut (B) (not included) and ferrule (not included) on copper tubing (not included) as shown.
-If you are using plastic tubing (B), insert the molded end(Bulb) of the plastic tubing (B) into the compression fitting.
Do not use without the molded end(Bulb) of CAUTION the plastic tubing (B).
2.Tighten the compression nut (B) onto the compression fitting. Do not
3.Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 1/4“ of the plastic tubing to make sure you get a snug,
before using icemaker
Remove
- Hold the handle as shown in Figure1.
-Slightly pull up the bottom part.
- Take out the ice bucket slowly.
Install
- Assemble the icemaker in the | Figure 1 | |
reverse order of disassembly. |
| |
- Push the bucket in firmly until |
| |
you hear a clicking sound. |
| |
- If the bucket does not fit into its |
| |
place, turn the gear handle on its |
| |
back by 90 degrees and reinstall |
| |
it again as shown in Figure 2. | Figure 2 | |
Before calling service | ||
|
-Any sounds you hear when
the ice maker dumps ice into the bucket are part of normal operation.
-If you don’t dispense ice for a
long period of time, the ice may form clumps in the ice bucket.
If ice clumps form, remove the | Ice Chute |
| |
remaining ice and empty the |
|
bucket.
-When ice does not come out, check for ice stuck in the chute and remove it.
-When Ice Off blinks on the display panel,
CAUTION | reinsert the bucket and/or make sure it’s | |
installed properly. | ||
|
-When the door is open, the Ice and water dispenser do not work.
-If you close the door hard, it may cause water spilling over the ice maker.
-To prevent dropping the ice bucket, use both hands when removing it.
-To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.
-Be sure not to put your hand or any object into the ice chute. It may cause personal injury or damage mechanical parts.
Removing residual matter inside the water supply line after installing filter.
1.Turn ON the main water supply.
2.Press the Water button and push the Dispenser Lever.
3.Flush 1 gallons of water through the filter before use. (Flush approximately 6 minutes.) This will clean the water supply system and remove air from the lines.
4.Additional flushing may be required in some households.
5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.
A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
10_ setting up