Samsung SHR-3010 user manual Rear View

DIGITAL VIDEO RECORDER

GB GB

Rear View

1 2 3 4 5 6 7 8 9 10 11

				No	Name		Function
No	Name		Function	8	EXTERNAL I/O	●	ALARM IN: In the N.C. (Normally Closed) mode, the system
1	RS232 PORT	Serial Port for remote control.			PORT		recognizes an alarm when a High (5V) signal is input for over
							0.5 seconds. In the N.O. (Normally Open) mode, the system
							recognizes an alarm when a Low (0V) signal is input for over
2	RS485 PORT
		Serial Port for remote control.					0.5 seconds. (Please refer to “➁ ALARM DETECT TYPE”
							on p. 3-18.)
3	VIDEO IN/OUT	Composite image signal I/O terminal (BNC Style Connector).				●	ALARM RESET: The alarm mode is cleared when a Low (0V)
							signal is input for over 0.5 seconds.
4	AUDIO IN/OUT	Audio Signal Input/Output Jacks (RCA Jacks).				●	ALARM OUT: A High (5V) signal is output during alarm
							recording.
						●	TRIGGER OUT: This signal is for switching the recording
	LAN
5		LAN Cable Connection Terminal.					output screen of the Multiplexer.
						●	REC IN: The system begins recording when a Low (0V) signal
6	MODE	It is the DIP switch to set System ID, Direct Communication,					is input for over 0.5 seconds.
						●	DISK END: If the DISK END MODE of the RECORD
		Termination, etc.
							MODE SETUP is set to STOP, a Low (0V) signal is output for
		● 1~5	: System ID.				about 1 second when the HDD becomes full during recording.
		● 6	: Not Use.				(Please refer to “➃ DISK END MODE” on p. 3-16.)

●7 : Termination On/Off (Of all the directly connected

systems, it sets the last system as On). 9 FAN Fan

●8 : Not Use.

			10	AC IN	Connects power cable.
	SCSI
7		SCSI Connector for Data Backup
				POWER	Power On/Off button.
		11

1-5 1-6