How to Install
How to Install the Camera (using the Embedded Housing)
①Make a hole of 155mm in diameter in the ceiling to install the camera. Pull the cable down through it.
②Connect the video cable, controller cable and power adapter cable to the mounting bracket. (See Page 19)
Controller connection cable
Video connection cable
Power adapter connection cable
③Fix the mounting bracket to the Embedded housing using three screws.
④Fasten the eye bolt on the housing and fix the housing to the ceiling, using the cable to prevent it from falling.
⑤ Fix the housing to the ceiling using three screws.
⑥ Connect the Installation bracket to the connector of the speed dome camera.
⑦ Insert the pin at the bottom of the camera into the bracket fixing hole and turn it anticlockwise to secure.
⑧Fasten the lock screw.
⑨Place the external cover over the housing and then rotate and fix it.
Embedded Housing | ENGLISH |
| |
Ceiling |
|
Hole for Fixing the Dome Camera |
|
Installation Bracket |
|
Installation bracket connector |
|
Camera connector |
|
Installation Pin |
|
Screws to prevent the |
|
camera from coming loose. |
|
External Cover (Decoration ring)
Cautions
·Check the power adapter input power before connecting the power supply.
·Install the camera using the installation template and cable and fixing screws that are supplied separately for installations without a housing.
·Note that the locking screws should be fastened. If one of the locking screws is not properly fastened, the camera may fall due to vibration or impact once it is installed.
24 | SPEED DOME CAMERA | SPEED DOME CAMERA | 25 |
|
|
|
|
