Camera setting
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Press the Enter key
Initialize
Power On Reset
Factory Default Set Camera Default Set
Auto Refresh | 7Days |
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Status
Press the Enter key
Cam Model =22NC Cam Version=03.05 Dome Version=01.00 Con Protocol=SAMSUNG Dome ID=001
Come Mode=DUPLEX
Factory Set=ON
ENGLISH
6) Initialize Setting
①Power On Reset
·Initialize a camera to the status prior to power supply
②Factory Default Set
·Initialize to the factory default. Data such as preset is deleted. This function is used to initialize a variety of settings. However, the digital zoom factor is not changed.
③Camera Default Set
·When a single camera module is replaced due to a defect only in that camera, Camera Default Set is used to
set the replacement camera module to the setting of the previous camera.
④Auto Refresh
·Optimize the built- in electrical circuit and the status of fixtures and devices in a camera at a
This is used for keeping, maintaining and correcting the camera settings when a camera directly faces a specific light source, or the setting is not preserved because the camera has been rotating left, right, up and down in a specific area for a long time.
The default is 7 Days. ·OFF, 1~7Days
Auto Refresh won’t run when OFF is selected. Select between 1~7 Days, and Auto Refresh will run at the selected intervals.
Auto Refresh takes less than about 10 seconds.
The message “Auto Refresh” disappears when the operation is completed.
7) Status
Displays the dome camera setting.
Cam Model =22NC | Mounted Camera Model |
Cam Version=03.05 | Mounted Camera S/W Version |
Dome Version=01.00 | Control Board S/W Version |
Con Protocol=SAMSUNG | Setting Protocol |
Dome ID=001 | Dome Camera ID |
Communication Mode Setting Status | |
|
|
50 | SPEED DOME CAMERA | SPEED DOME CAMERA | 51 |
|
|
|
|
