Sansui TV19PL120DVD Basic TV functions, Channel Selection, Quick View, Volume adjusting, Mute

Basic TV functions

Note:

¥If the built-in tuner does not receive any signal (e.g. if no aerial is connected or if the broadcast transmission stops) during TV operation, this unit will switch to standby after approx. 15 minutes.

Channel Selection

With the 10 Number Buttons.

Example:

¥No. 2: Press 0 and within 2 seconds, press 2. The station stored in the CH2 position will appear.

¥No. 29: Press 2 and within 2 seconds, press 9. The station stored in the CH29 position will appear.

With the P + or P – buttons.

Press P + or P – to change the program number up or down. Each change will take approx. 2 seconds.

¥ In DTV mode

Min. numbered Digital CH Max. numbered Digital CH

¥ Other than DTV mode

Min. numbered Analogue CH			Max. numbered Analogue CH
DVD	PC	HDMI	COMPONENT	AV2 AV1

With the CH LIST button.

Press CH LIST to display channel list. Press C or D to select the desired pro- gram, then press CH LIST to display the selected program.

If the auto search only stored 5 stations, only these 5 will appear. Concealed channels will not appear (see page 12).

Quick View

button allows you to go back to the last selected channel or input source.

Volume adjusting

Press + or – to adjust the volume. The volume level indicator disappears after 4 seconds.

MUTE

Press . The sound will be cut off. MUTE will display on the screen for approx.

4 seconds. The muting can be released by pressing again or + or –.

DISPLAY

In the analogue TV mode: Press . Channel number and picture size setting will appear for approx. 4 seconds.

In the digital TV mode: Press . The program information will appear (see ÔChannel bannerÕ on page 27).

S T E R E O	1
	B B C 1

	A V C O L O U R
A U T O		A U T O

SLEEP TIMER

Press . SLEEP and the number of minutes until the set is due to shut - off will appear. Each time you press the SLEEP time will decrease in 10 minute intervals.

When the displayed time runs out, the unit will switch to standby. The display will disappear after approx. 4 seconds.

To cancel the sleep timer:

Press repeatedly until Ô0Õ appears.

S L E E P 1 2 0

14

50A0201A_p10-15.p65 14 9/12/07, 4:55 PM