Sansui TV19PL120DVD Safety warnings, Batteries, Safety note, Standby, Interference, Temperature

Safety warnings

Damage - Never use your TV if it		Batteries	Attention!
is damaged in any way. Always		Batteries are easily swallowed by	Cleaning instructions for your LCD TV.
place your TV on a flat level surface		young children. Do not allow young	Safety note:
avoiding anywhere which may be		children to play with the remote
subject to strong vibration.		control unit.	Before you start to clean, switch the
			set's power off completely and
Weather - It is advisable to unplug		Covers - Do not remove any fixed	disconnect the plug from the mains
the aerial during an electrical storm.		covers as this may expose danger-	power supply.
Moisture - Do not allow your TV to		ous voltages.	Be careful not to scratch the plastic
		Standby	coated front panel - it is highly
be exposed to rain, moisture or dust.			vulnerable to accidental scratching
If any liquid is spilt into your TV it		Do not leave your TV in standby for	(e.g. by fingernails or other sharp
can cause serious damage. If you		long periods of time e.g. overnight	items).
spill any liquid into your TV switch it		or while on holiday. We recommend	While cleaning, do not wear
off at the mains immediately. Con-		that you switch off / unplug at the	jewellery that could cause surface
tact your store.		mains power supply.	scratching (such as rings, wrist-
Interference		CAUTION:	watch, etc.).
			Use a lint-free cloth and pure water
Do not place your TV on or near		THIS UNIT IS A CLASS 1 LASER PROD-	to clean with, but make sure the
appliances which may cause		UCT. HOWEVER THIS UNIT USES A	cloth is thoroughly wrung out so that
electromagnetic interference (TV or		VISIBLE LASER BEAM WHICH COULD	it is just damp and not soaking wet -
Hi-Fi speakers). If you do, it may		CAUSE HAZARDOUS RADIATION EX-	also make sure that the cloth is free
adversely affect the working of the		POSURE IF DIRECTED. BE SURE TO	from any dirt that could cause
unit, causing erratic playback,		OPERATE THE PLAYER CORRECTLY AS	scratching to the surface.
distorted picture or sound.		INSTRUCTED.	Wipe the set clean using minimal
Temperature		WHEN THIS UNIT IS PLUGGED INTO	pressure.
			Do not use standard window
		THE WALL OUTLET, DO NOT PLACE
Avoid extremes of			cleaning fluid. Its alcohol / ammonia
		YOUR EYES CLOSE TO THE OPEN-
temperature, either hot or			will dissolve the front window's
		INGS TO LOOK INTO THE INSIDE OF
cold, place your TV well		THIS UNIT.	coating.
away from heat sources such		USE OF CONTROLS OR ADJUST-	Never use solvent or thinner. Never
as radiators or gas/electric			use special cleaners which are
fires.		MENTS OR PERFORMANCE OF PRO-	designed for cleaning PC Monitors
Ventilation		CEDURES OTHER THAN THOSE	or CRT TVs.
		SPECIFIED HEREIN MAY RESULT IN	Finally carefully rub dry with a clean
The TV must be well		HAZARDOUS RADIATION EXPO-	dry lint-free cloth.
ventilated. Do not cover your		SURE.	Do not use paper towels or tissues to
TV or place inside a small		DO NOT OPEN COVERS AND DO	clean the set - paper can disintegrate
confined space. It is recom-		NOT REPAIR YOURSELF. REFER SERV-	when wet or may leave a trail of
mended that you leave a		ICING TO QUALIFIED PERSONNEL.	dust behind. Some paper can also
10cm gap all around your			be abrasive and scratch your screen.
TV.	Plasma and LCD TV Screen Burn Warning
Note:
	A characteristic of Plasma and LCD TV Panels is that displaying the same image
¥ When installing the set on	for a long time may cause a permanent after-image to remain on the screen. This
a wall, allow at least 10 cm
	is called screen burn. Most pictures shown on your TV will be constantly moving
clearance between the rear
of the set and the wall.	and fill the screen.
Clearance of less than 10 cm
will obstruct the vents and	Examples of images that you need to watch out for are as follows (this is not an
cause the interior of the set
	all-inclusive list):
to overheat, resulting in faults
or damage to the set.	• Black Bars: If black bars appear at the left/right or top/bottom of the screen
¥ If the unit is mounted on the		it is recommended to change the format so that the picture fills the entire
wall, contact the shop		screen.
where you purchased the
	• TV Channel Logos: e.g. Shopping channel logos and pricing displays -
unit for advice, and leave
		especially if they are bright and stationary. Moving or low-contrast graphics
the installation work to
		are less likely to cause ageing of the screen.
experts. Incomplete
installation work can cause	• PIP and Multipip: Do not view for long periods of time using the PIP or
you injuries.	•	Multipip functions.
¥ The apparatus must be		Time Displays
connected to a mains	• Teletext: Do not view a stationary page for long periods of time.
socket outlet with a	• TV/DVD Menus: e.g. Listings of DVD disk content.
protective earthing	• Pause Mode: Do not leave the screen in pause mode for long periods of time,
connection.		e.g. When watching DVDs or videos.
¥ The socket outlet must be
installed near the	Note: To prevent screen burn if viewing any of the above for long periods of
equipment and easily
	time, reduce contrast and brightness when viewing. Once burn-in occurs it will
accessible.
	never disappear completely.

*The ÒHD readyÓ Logo is a trademark of EICTA.

50A0201A_cov-in.p65 2 9/12/07, 4:53 PM