CONNECTIONS
Connect the video camera and monitor TV as shown in the figure below.
NOTE: Before making the connections, make sure the devices are disconnected from the power outlet.
Video camera (sold separately)
To
VIDEO IN jack
IN OUT | IN OUT |
VIDEO | |
AC IN |
|
Power cord | To |
| VIDEO |
| OUT |
| jack |
IN OUT
AUDIO
A RS485 B
ADDRESS 485 TERMINATE
ON 
ON
PUSH 
OFF 232
OFF OPEN
REMOTE
RS232C
Monitor TV (sold separately)
From an external audio source
MIC IN
EXT | TIMER WARNING TAPE | SW | COM NON REC V.LOSS | ||||
TIMER IN OUT | OUT | END OUT OUT |
| OUT | OUT | ||
IN | OUT | COM | IN | OUT | COM | IN | OUT |
CLOCK SET |
| SERIES |
| EJECT | |||
ALARM |
| TRIGGER | IN | OUT |
|
| |
RESET |
| SHOT REC | ALARM |
|
| ||
IN |
| IN |
|
|
|
|
|
To remote control (sold separately)
To outlet | Coaxial cable | |
(sold separately) | ||
|
Power Cord Installation
1Plug the supplied power cord firmly into the AC power input AC IN ~ socket.
2Insert the plug of this power cord into a outlet.
About the memory reset
If the VCR location is changed or to cancel previous settings, please reset the memory as described below.
To reset the memory, press the ALL RESET button.
NOTE:
œThe time and date will be reset, and the quick method security lock will be cancelled. The (SECURITY LOCK) menu data cannot be reset.
NOTES:
œFor more details, please refer to the manuals accompanying all other devices. If the connections are not made properly, it may cause a fire or damage the equipment.
œYou can use a
œThe grounded power cord (3 pin plug) must be connected to a grounded power outlet.
œIf there is no video signal when the power is turned on, “NO VIDEO” will be displayed
œWhen both the VIDEO IN jack and
œWhen a multiplexer is used, a connection must be made between the SW OUT terminal on the VCR and the SW IN terminal on the multiplexer. If the connection is not made, depending on the recording mode a part of the image may not be recorded.
10 | English |
