Sanyo PLC-XU106K Maintenance and Cleaning Cleaning the Filters, Resetting the Filter Counter

Maintenance and Cleaning

Cleaning the Filters

Filters prevents dust from accumulating on the optical elements inside the projector. Should the filters become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the filters immediately. Clean the filter by following the steps below.

1	Turn off the projector, and unplug the AC power cord
	from the AC outlet.
2	Turn the projector over and remove the filters by pulling
	the latches upward.
3	softly.Gently clean the filters by using a brush or rinse them
4	When rinsing the filters, dry them well. Replace the
	filters properly. Make sure that the filters are fully

inserted to the projector.

CAUTION

Do not operate the projector with the filters removed. Dust may accumulate on the optical elements degrading picture quality.

Do not put anything into the air vents. Doing so may result in malfunction of the projector.

RECOMMENDATION

We recommend avoiding dusty/smoky environments when you operate the projector.. Usage in these environments may cause poor image quality..

When using the projector under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector degrading the quality of a projected image. When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.

Filters

Pull up and remove.

Note:

When reinserting these filters, be sure that the slit part is facing the outer side.

Filter counter

H

Resetting the Filter Counter

Be sure to reset the Filter counter after cleaning or replacing the filters.

1	Press the MENU button to display the On-Screen
	Menu. Use the Point ▲▼ buttons to select Setting and
	then press the Point ► or the SELECT button.
2	Use the Point ▲▼ buttons to select Filter counter
	and then press the SELECT button. Use the Point ▲▼
	buttons to select Filter counter reset and then press
	the SELECT button. Filter counter Reset? appears.
	Select Yes to continue.
3	Another confirmation dialog box appears, select Yes to
	reset the Filter counter.

Filter counter Reset?

appears.

Select Yes, then another confirmation box appears.

Select Yes again to reset the Filter counter.

61