Sanyo PLC-XU355A Part Names and Functions Remote Control Battery Installation, Adjustable Feet

Part Names and Functions

Remote Control Battery Installation

1	Open the battery	2	Install new batteries	3	Replace the
	compartment lid.		into the compartment.		compartment lid.
	Press the lid		Two AAA size batteries
	downward and slide it.		For correct polarity
			(+ and –), be sure

battery terminals are in contact with pins in compartment.

To ensure safe operation, please observe the following precautions : ● Use two (2) AAA or LR03 type alkaline batteries.

● Always replace batteries in sets.

●Do not use a new battery with a used battery.

●Avoid contact with water or liquid.

●Do not expose the remote control to moisture or heat.

●Do not drop the remote control.

●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

●Risk of an explosion if battery is replaced by an incorrect type.

●Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) when pressing the buttons. Maximum operating range for the remote control is about 16.4'(5 m) and 60 degrees in front of the projector.

16.4' (5 m)

30°

30° Remote control

Adjustable Feet

Projection angle can be adjusted up to 12.0 degrees with the adjustable feet.

Lift the front of the projector and press the feet lock latches on both side of the projector.

Release the feet lock latches to lock the adjustable feet and rotate the adjustable feet to a proper height and tilt.

Keystone distortion can be adjusted automatically with the Auto setup function or manually by using the remote control or the menu operation (see pages 25, 47-48).

Feet Lock Latches

Adjustable Feet

14