Sanyo PLC-XU305A Rear Terminal, Part Names and Functions, ① CONTROL PORT, ③ MONITOR OUT

Part Names and Functions

Rear Terminal

		③	④	⑤
①	②

⑫ ⑪ ⑩ ⑨ ⑧ ⑦ ⑥

①CONTROL PORT

When the projector is controlled by a computer, connect to this jack with serial control cable.

②COMPUTER IN 1 / COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.16,18).

③MONITOR OUT

This terminal can be used to output the incoming analog RGB signal from COMPUTER IN 2 / DVI-I terminal or COMPUTER IN 1/COMPONENT IN terminal to the other monitor (p.16).

④COMPUTER IN 2 / DVI-I

Connect computer output (Digital/Analog DVI-I type) to this terminal (p.16).

⑤LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual “Network Set-up and Operation”).

⑥USB Connector (Series A)

Connect the USB cable (refer to the owner’s manual “Network Set-up and Operation”).

⑦S-VIDEO IN

Connect the S-VIDEO output signal from video equipment to this jack (p.17).

⑧AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.16-18).

This terminal outputs sound from AUDIO IN terminal (⑨ or ⑩).

⑨COMPUTER 1 / COMPUTER 2 AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to ② or ④ to this jack (pp16, 18).

⑩AUDIO IN

Connect the audio output signal from video equipment connected to ⑦ or ⑪ to this jack. For a

mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.17).

⑪VIDEO IN

Connect the composite video output signal to this jack (p.17).

⑫USB Connector (Series B)

In order to operate the computer with the remote control and use the PAGE ▲▼buttons on the remote control during a presentation, connect the USB port of the computer to the USB terminal with a USB cable (not supplied) (p.16).