Sanyo PLC-XU305A, PLC-XU355A Appendix, No image, No sound, The color is strange, the operation

	Appendix
No image	– Check the connection between your computer or video equipment
	and the projector. See pages 16-18.
	– See if the input signal is correctly output from your computer. Some
	laptop computers may need to change the setting for monitor output
	when connecting to a projector. See your computer’s instruction
	manual for the setting.
	– It takes about 30 seconds to display an image after turning on the
	projector. See page 20.
	– Check the Input signal, color system, video system or computer
	system mode.
	– Make sure the temperature is not out of the specified Operating
	Temperature (41˚F–95˚F [5˚C–35˚C]).
	– When No Show function is operating, the image cannot be displayed.
	Press the NO SHOW button or any other button on the remote control.
No sound	– Check the audio cable connection from audio input source.
	– Adjust the audio source.
	– Press the Volume + button. See page 26.
	– Press the Mute button. See page 26.
	– When the AUDIO OUT is plugged-in, the projector's built-in speaker
	is not available.
	– Is the image projected? You will hear the sound only when the image
	is projected.
The color is strange.	– Check the Input signal, color system,video system or computer
	system mode.
	– Make sure Blackboard is not selected on Image select
	menu. See pages 35,42.
Some displays are not seen during	– Check the Display function. See page 48.
the operation.

Auto PC adjustment function does not work.

–Check the Input signal. Auto PC adj.function can not work when

480p,575p.720p,480i,575i,1035i or 1080i is selected or when the digital signal is input into DVI terminal. See page 32.

The setting does not remain after	– Make sure you selected Store after adjusting setting. Some settings
	can not be stored if not registered with Store. See page 37,44.
turning off power.
	– Power management function can not work while Freeze or No
Power management does not work.	Show function is running. See page 53.
Capture function does not work.	– Check the connection and the input signal to see if there is signal.
	– Make sure Off is not selected at any function of "Auto setup".
Auto setup does not work properly.	See page 47.
	– Make sure On is not selected at the Ceiling function. See page 52.

Auto keystone function does not work even when the projector is tipped.

–Make sure the Auto keystone function is not set to Manual. Press the AUTO SET UP button on the top control. See pages 25,47.

67