Sanyo POA-LN02 Change the mode of the registered monitor, Status, indications, Mode, Operation

62

Chapter 4 Controlling the Monitor

Change the mode of the registered monitor

To change the mode of the registered monitor, select a mode with the pull-down menu button under the IP address of the target monitor and then click Set button.

Mode	Operation
Control	Controlling the monitor
Both control	Controlling and displaying pictures
Visual control	Displaying the pictures
OFF	Excluding from the multi-control
Delete	Deleting from the multi-control

*The multi control item is not changed during using the network viewer function. It is not available with the light mode.

Status

If some of the registered monitors are disabled by some reasons (such as disconnecting the power source, dis- connecting the LAN cable, disconnecting from the net- work), control changes will continue to be effective for the monitors that are still active. At the same time, the deactivated monitors are excluded from the multi-con- trol. The status of the registered monitors are indicated under the monitor name. See the table below for status

indications.	Status
Status	Description
(blank)	The monitor is connected to the network correctly
No connect	The monitor may not be connected to the network. Please check the connection
	and network configuration of this monitor.
PIN code error	The PIN code is incorrect. The PIN code for the multi-controlled monitors must be
File Error	the same. Change the PIN code of this monitor to the common PIN code.
	Not displaying the images. Check if this monitor is using the Network Capture func-
	tion or Network Viewer function individually, or in the standby mode.

* The network unit updates the status at the time when the multi-control function was executed.

If the multi-controlled monitor is in the standby mode, any change is not effective except timer setting.

Cannot register, delete or change the multi-control setting during using the network viewer func- tion.

It is recommended that a specified monitor should be chosen for setting as a master when you use this multi-control function. The control for the multi-controlled monitors will become too complicated operation if this function is used for each monitor.

If the registered monitor is not connected to the network, it will take some time to complete the multi-control operation because of waiting for the response from each registered monitor. There are some disabled items in the multi-control function for the light mode.