Sanyo RL2500 manual Making a PCS Ready Link Call by Entering a Number

Making a PCS Ready Link Call by Entering a Number

1.From standby mode, enter the PCS Ready Link number you want to dial.

2.Press to place the PCS Ready Link call. Continue holding

to take the floor and speak.

The contact’s name appears if there is a matched number in your PCS Ready Link List.

3.Continue with the PCS Ready Link call, pressing and holding

to speak and releasing it to allow others to reply.

4.When the call is finished, press .

–or –

1.Press R-Link(left softkey) or press to access the PCS Ready Link List.

2.Press Go to (left softkey), highlight Enter R-Link#and press .

3.Enter the PCS Ready Link number you want to dial.

4.Follow steps 2-4 above.

Note: PCS Ready Link numbers must contain 10 digits (area code + phone number) or 11 digits beginning with 1. Your PCS Ready Link number is the same as your PCS Phone number.

Receiving a PCS Ready Link Call (1-to-1 Call)

1.Make sure your phone’s PCS Ready Link mode is enabled (see “Setting PCS Ready Link Mode” on page 27).

2.When you receive a PCS Ready Link call from a contact, “R-Link Call,” the contact’s name, and the PCS Ready Link number appear on the display. (You do not need to take any action to answer the call.) The caller may choose to alert you and simply talk. If so, you will see “Floor is open.” and can then press and

hold to reply/answer.

3.If the person placing the call has kept the floor (held the Ready Link button), you will see the contact name and PCS Ready Link number along with “has floor.”, and you will hear the caller speaking.

Section 2: Understanding Your PCS Phone

2A:Your PCS Phone – The Basics 31