7-5. Removing and Installing the Grille
Basically, these models can be installed and wired without removing the grille. If access to any internal part is need- ed, follow the steps as given below.
How to remove the grille
(1)Open the front panel until it is nearly horizontal, grasp the sections near the front panel arms on both sides, and then remove the panel by pushing the arms towards the outside while pulling the panel towards you. (Fig. 9)
(2)Lift the
(3)Remove the 4 screws. Grasp the grille on both bottom sides, and pull it towards you slightly. (Fig. 10)
(4)Press the 2 tabs on the top of the grille to disengage them. (Fig. 10)
(5)Pull the grille towards you to remove it. (Fig. 10)
Front panel | Arm |
|
Grille
Screw | ||
Protrusions | ||
| ||
Fig. 9 | Fig. 10 |
How to replace the grille
(1)Insert the bottom of the grille into the frame.
(2)While aligning both edges of the grille with the frame, move the grille horizontally and insert the top and bottom into the frame.
(3)Press the grille firmly with your hand to ensure no gap exists between the frame and grille.
(4)Tighten the 4 screws.
(5)Grasp the sections near the front panel arms on both sides, and hold the front panel so that it is nearly horizontal. Push the arm shafts towards the outside so that they come into contact with the top of the indentations on the right and left sides of the air conditioner. Then push firmly until the arm shafts click into place. (Fig. 11)
(6)Insert the top of the
(7)After closing the front panel, press firmly on the parts indicated by the arrows to securely fasten the panel in place. (Fig. 12)
NOTE
Check that no gap exists between the frame and the grille.
Front panel
Indentation
Arm
Fig. 11
Pin
Fig. 12
37
