Sanyo VCC-WD8575P JSet “MENU” to “BACK” and press the SET button, KSelect “POLARITY” and specify a polarity for the signal

Specifying Alarm Input

ISelect “DURATION” and specify a time until the next alarm input becomes enabled.

MOTION SETTING

MASKING	OFF
SENSITIVITY	SET
DURATION	5S
PRESET	OFF
MENU	BACK

•Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M (S = second, M = minute)

Note: A new detection or an alarm output cannot be performed until the specified time of duration elapses.

JSet “MENU” to “BACK” and press the SET button.

RReturns to the “ALARM IN SETTING” screen.

KSelect “POLARITY” and specify a polarity for the signal.

	ALARM IN SETTING
	MODE	ALM
	POLARITY	NO
	MOTION	OFF
	MOTION SET	SET
	ZOOM	OFF
	ZOOM TIME	5S
	DURATION	5S
NO	: Normal Open (When closed, alarm input is detected.)
NC	: Normal Close (When opened, alarm input is detected.)

LSelect “MOTION” and specify the detection logic of the motion sensor and the alarm input.

OFF : The motion sensor is unused: Detects when an external sensor responded.

AND : Detects when both the motion sensor and an external sensor responded. (You cannot select this option when the “MODE” is specified with “COLOR”.)

OR : Detects when either the motion sensor or an external sensor responded. (During the “COLOR” mode, detection is solely dependent on the responsiveness of the motion sensor.)

Note: While the “SENSE UP” capability is enabled, the motion sensor does not work. If “SENSE UP” has been set to other than “OFF”, this setting is not available. (See page 28)

41English