ALARM IN SETTING
MODE | ALM |
POLARITY | NO |
MOTION | OFF |
MOTION SET | SET |
ZOOM | OFF |
ZOOM TIME | 5S |
DURATION | 5S |
PRESET | OFF |
MENU | BACK |
•Select from: OFF (no zoom), x 1.4, x 2.0, x 2.5.
Note: • If you specify the “ZOOM” function, the center of the screen will be electronically zoomed in automatically when an alarm signal is supplied from external devices such as door switch or infrared sensor, etc.
•Even though the “EL ZOOM” is already specified, the
“ZOOM” settings you configure here will override it. Then “EL ZOOM” will be set to “OFF”. (See page 54)
•When “ZOOM” is set to “ON”, the detection zone of the motion sensor is limited to CENTER (initial position and size). When switching “ZOOM” back to “OFF”, the above setting will revert to those specified before “ZOOM” was set to “ON”. Also note that no adjustment is possible for “BLC” – “CENT” if “ZOOM” is set to “ON”. (See page 23)
•If “BLC” has been set to “CENT”, the “ZOOM” function will not work. (See page 22)
Specifying Alarm Input
NSelect “ZOOM TIME” and specify duration time for zooming (if you specified “ZOOM” to other than “OFF” in step M).
•Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M (S = second, M = minute)
OSelect “DURATION” and specify a time until the next alarm input becomes enabled.
•Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M (S = second, M = minute)
Note: • When the “MODE” is specified with “COLOR”, this setting will not appear.
•When the alarm output starts, a new detection or an alarm output cannot be performed until the specified time of duration elapses.
PSet “MENU” to “END” and press the SET button.RFinishes the settings screen and returns to the normal monitoring screen.
•If you want to return to the previous screen, select “BACK” and press the SET button.
MEMO: You can blink the camera name on the screen when an alarm signal is supplied. (See page 45)
Settings/ | Adjustments |
English 42