Installing and Configuring the Module
Turn the locking ring to align an arrow with the key. Then align the key with the keyway. As a result, the locking tab, groove and lock should also be aligned.
Slide the clasp up to the locking ring. Gripping the cable with the clasp, plug the cable into the lower (receive) cable connector. If it does not connect easily, realign the key with the arrow and try again.
Connector
Locking Tab
Keyway |
|
|
| Locking Ring | |
|
|
|
| ||
|
|
|
|
| Fiber Cable Clasp |
|
|
|
|
| |
| Key | ||||
Figure 13 Attaching the Cable
Turn the cable to the right, so that the tab locks securely. You may leave the fiber cable clasp on the cable for future use, but slide it off the boot of the cable to allow the module door to close.
Repeat this process with the remaining strand of cable and the upper (transmit) cable connector.
When connecting the cable to the hub, make sure that the strands are crossed. The transmit port of one device should be linked to the receive port of the other.
840 USE 115 00 Version 1.0 | 19 |
