Connecting Other Components
Speakers
Caution: Do not connect external speakers to more than one audio source at a time. You can connect a set of
speakers to either the TV or the Amplifier but not to both at the same time. If you connect the same speakers to both the TV and the amplifier, you will damage your equipment.
Speakers
Connecting Speakers to TV
If you do not connect an Amplifier or Receiver to your TV, you can connect external speakers to the TV to enhance sound from the TV.
The diagram below shows how to connect external speakers to the speaker terminals on the back of the TV.
1.Remove the vinyl covering and twist the wire core.
2.Press and hold the lever down while inserting the wire core into the hole. Be sure to connect (+) to (+) and
3.Release the lever.
Notes:
•After releasing the lever, pull gently on the wire and check that it is connected securely to its terminal.
•Do not allow the wire core to protrude from its terminal or contact other wires or terminals. If the cores of two wires
touch each other, damage to components could result.
Back of
To obtain a "surround sound" effect, place the external speakers in the rear of the viewing area, and slide the speaker switch to INT/EXT SURR. This provides full power to the TV's internal speakers for the front sound and a surround signal to the rear speakers.
INT/EXT
EXT | Uldenlng |
SURR | Ar,,,, |
Connecting Speakers to Amplifier or Receiver
If you connect an Amplifier or Receiver to your TV, connect the speakers to the Amplifier/Receiver instead of the TV. Sound from the TV will then come through the Amplifier/Receiver and the TV's internal speakers. You can turn off the TV's internal speakers with the SPEAKERS: ON/OFF function described on page 9.
The diagram below shows how to connect external speakers to the speaker terminals on the back of a typical Amplifier/Receiver. Check the owner's manual for your Amplifier/Receiver if its speaker terminals look different than those shown below.
Notes:
•After connecting speaker wire, pull it gently and check that it is connected securely to its terminals.
•Do not allow the wire core to protrude from its terminal or contact other wires or terminal. If the cores of two wires touch each other, damage to components could result.
Back of Amplifer / Receiver
The speaker switch on the back of the TV allows you to use the external speakers.
To enhance the sound from the TV's speakers, place the speakers in the front of the viewing area (usually beside the
TV), and slide the speaker switch to EXT. This provides full power to the external speakers for a "fuller" sound. The internal audio from the TV's speakers will be muted.
INT/EXT |
|
|
EXT SPEAKER SURR | [_ | u,_l=.g % |
32
