Installation Instructions
1.Install a manual gas line
range_ Make sure everyone operating the range knows where and how to shut off the gas supply to the range.
2.Install mate 1/2" flare union adapter to the i/2" NPT internal thread elbow at inlet of pressure
regulator. On models equipped with standard twin burners, install the male pipe thread end of the 1/2" flare union adapter to the 112" NPT internal thread
at inlet of pressure regulator. Use a
When installing the range from the front, remove the 90 ° elbow for easier installation.
3.Install male 1/2" or 3/4" flare union adapter to the NPT internal thread of the manual
4.Connect flexible metal appliance connector to the adapter on the range. Position range to permit
connection at the
5.When all connections have been made, make sure all range controls are in the OFF position and mrn on the main gas supply valve. Use a liquid leak
detector at all joints and connections to check for leaks in the system.
CHECK FOR GAS LEAKS.
CAUTION: DO NOT USE A FLAME TO
When using test pressures greater than 112 psig to pressure test the gas supply system of the residence,
disconnect the range and individual
isolate the range from the gas supply system by c!osing the individual
coo 0ood)
STEP 3
Electrical Connections
(on some models)
Electrical Requirements
protected by a
Extension Cord Cautions
Because of potential safety hazards associated with
certain conditions, we strongly recommend against the use of an extension cord. However, if you still elect to
use an extension cord, it is absolutely necessary that it
be a ULdisted,
the cord in amperes be equivalent to, or greater than, the branch circuit rating.
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE PROPERLY GROUNDED.
The power cord of this PREFERRED
appliance is equipped with a
(grounding) plug which mates with a
standard
grounding wall
receptacle to minimize
the possibility of
electric shock hazard
from this appliance.
The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded.
Where a standard
encountered, it is the personal responsibility and
obligation of the customer to have it replaced with a
properly grounded
DO NOT, UNDER ANY CIRCUMSTANCES, CIFI"
OR REMOVE THE THIRD (GROUND) PRONG
FROM THE POWER CORD.
34