Sears 71668, 71751 STEP Seal the Openings, Electric Disconnect, W_dl Be Disconnected Infrequently

A: Usage Sit_aations Where Appliance Power Cord

W_dl Be Disconnected Infrequently.

TEMPORARY		METHOD
(Adapter	plugs	not
permitted in Canada)						_.___,
Atign	large	prongs/slots		_		_"_'_JJ f
	\		_/I/'	_"	Ensure	proper ground
		'It	t/ ! I		and firm oonnection
					before	use

An adapter may be used only on a 15-amp circuit. Do not use an adapter on a 20-amp circuit° Where local

codes permit, a TEMPORARY CONNECTION may

be made to a properly grounded two-prong wall receptacle by the use of a UL-listed adapter, available at most hardware stores. The larger slot in the adapter must be aligned with the larger slot in the wall receptacle to provide proper polarity in the connection of the power cord.

CAUTION: Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal, and not insulated, and the wall receptacle is grounded through the house wiring. The customer should have the circuit checked by a qualified electrician to make sure the receptacle is properly grounded.

When disconnecting the power cord from the adapter, always hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use. Should this happen, DO NOT USE the appliance until a proper ground has again been established.

B: Usage Sltuataons Where Applianc Power Cord

W'Lll Be Disconnected Frequently.

Do not use an adapter plug in these situations because

disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal.. The customer should have

the two-prong wall receptacle replaced with a three-

prong (grounding) receptacle by a qualified electrician before using the appliance.

The installation of appliances designed for mobile home installation must conform with the

Manufactured Home Construction and Safety Standard, Tide 24 CFR, Part 3280 (formerly the

Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such

standard is not applicable, the Standard for

Manufactured Home Installations, latest edition

(Manufactured Home Sites, Communities and Set- Ups), ANSI A225.1, latest edition, or with local codes.

In Canada, mobile home installation must be in

accordance with the current CAN/CSA Z240/Mtl

Mobile Home Installation Code.

Electric Disconnect

1.Locate disconnect plug on the range back°

2.Pinch sides of connector and pull out of range back°

You will have this disconnect plug:

STEP 4

Seal the Openings

Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.

(continued next page)

35